Sceptre tv no signal

Try a different electric outlet. Try a new power cord. Sometimes with bad signals the picture will fail but the audio will still be present. Check if the video cable wire is loose.

Guides and support for various television TV brands and styles. Posted: Nov 10, I have a Sceptre 32inch LCD TV which after being turned on shows the Sceptre logo on the screen and then turns blue stating no signal on the screen. The tv does not have sound or picture. I was wondering if it was the power supply or the mainboard which is causing the problem.

Sceptre tv no signal

.

Television Guides and support for various television TV brands and styles. See if that helps.

.

Please make sure that your TV source is on and that you have selected the correct input for your TV source. If your TV is connected to a cable source, make sure the coaxial cable is properly connected to the wall outlet and the back of the TV. If you have established that the TV source is active, please check that all hardware connections are in place and secure, such as HDMI cables, component cables, and VGA cables. Make sure the device you are attempting to display on the TV is powered on and supports the resolution you have set on your TV. You may also try a reset on the TV. This can be done by unplugging the power cord and waiting a few moments before plugging the power cord back in. After the TV powers back on, the TV will be reset to its factory default settings. Getting a signal on a Sceptre TV is relatively straightforward. If you have cable or satellite service, the first step is to make sure any cables connecting the TV to the source e.

Sceptre tv no signal

For decades, Sceptre TV has been a popular brand. They have recently started selling their TVs at a low price, making them more affordable for the average consumer. However, several users are reporting various issues with recent subpar Sceptre TV models. The most common Sceptre TV problems include power failures, black screens, audio problems, blurry pictures, and connectivity glitches. These Sceptre TV problems can be frustrating and hard to troubleshoot, so you should be aware of the most common issues that you may experience.

Akshay kumar comedy movies

If it does not work then it tells you the problem lies with the device. Please see if that solves your issue. MY TV screen is black but I still have sound 1. The power supply must be working as the logo and blue screen and message are appearing. Use regular tape to remove the glue residue by taping the glue residue then pulling the tape up. If you are watching the TV tuner make sure the signal is good. Try a known to be working HDMI cable to see if that helps. If the remote control or bezel is dirty to the point where you cannot simply dry wipe it, please lightly dampen the wiping material the wiping material cannot be dripping wet, because if water drips into the panel it will cause malfunction and possible permanent damage to the panel which will not be covered under the warranty with clean water and wipe again. Also check that your aerial lead is plugged in correctly. Check if the video cable wire is loose. These type of chemicals might damage the housing and the LCD glass. Remote is not functioning properly 1. Remove the batteries out of the remote for 30 minutes.

Guides and support for various television TV brands and styles.

If this is a TV, see if all the sources are giving you the same problem. Use regular tape to remove the glue residue by taping the glue residue then pulling the tape up. Please exchange it with your retailer. Try to remove the sticker by gently picking at the sides. If they do not then most likely it is the cable or satellite box, please check with your service provider for further help. Remove the batteries out of the remote for 30 minutes. I have a Sceptre 32inch LCD TV which after being turned on shows the Sceptre logo on the screen and then turns blue stating no signal on the screen. Try the remote to see if it works. If the sticker still feels hard to peel off, repeat STEP 1. If there is it might be the device connected to your current source at fault. Remove the batteries out of the remote for about 10 minutes. Check the LED indicator light to see if it is lit.